Nordson VersaBlue VB Series, Manual

Page: 121 / 280

Profibus address 10
Control mode
Standard
Field bus
Dual
Control mode
Standard
Field bus
Dual
Operation
4-55
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
Profibus Setup (or One of the Other Field Buses)
The melters on the field bus each require an address for communication;
each address may be assigned only once in the entire field bus.
Profibus: The address is set on the IPC (Refer to Fig. 4-67).
10
Fig. 4-67 Profibus
ControlNet: The address is set with two decimal dials on the gateway
located in the electrical cabinet.
EtherNet/IP: The IP address is set with a PC or with the DIP switches on
the gateway located in the electrical cabinet.
Refer to separate document
Field Bus in Nordson Melters with IPC .
Touch to access information on the field bus data protocol. Refer to
section Troubleshooting, Checking Transmitted Field Bus Data .
Selecting the Control Mode
Standard: The melter is operated via the control panel.
Field bus: All screens can still be viewed, but the melter can no longer be
operated via the control panel. If this is attempted, The melter is in field bus
mode appears.
Dual: The melter can be operated via the control panel as well as by the
master.
Fig. 4-68
Standard
Field bus: Melter control
Enable motor 1
M2 M1
Field bus: Melter control
All motors ON/OFF
(collective enable)
Field bus: Melter control
Enable motor 2
Fig. 4-69 AND link in Dual mode