Nordson VersaBlue VB Series, Manual

Page: 219 / 280

Coupling
max. 5 mm
Sensor
max. 0.2 in
Repair
7-15
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
For more information on the coupling, refer to the manual VersaBlue ,
section Repair , chapter Attaching Gear Pump , beginning with point 5.
14. Slide the motor with the motor bracket in the slot until it lines up with the
first coupling element or protrudes no more than 1 to 2 mm (0.04 to
0.08 inch).
15. Align the motor bracket with the aid of an angle on the melter chassis;
refer to Figure 7-24.
For more information on the coupling, refer to the manual VersaBlue ,
section Repair , chapter Replacing Motor .
Fig. 7-24
16. Tighten the motor bracket screws.
Torque (screws): 20 Nm / 177 lbin
17. Tighten coupling screws.
Torque (screws): 36 Nm / 320 lbin
18. Align sensor. Refer to Fig. 7-25.
NOTE: The dimensions indicated in the drawing (5 mm / 0.2 inch) must be
complied with.
19. Check if the drive and output shafts are aligned at low speed (5 min
− 1
).
If not, align the motor anew.
20. Put the insulation blanket and protective panels back into place.
Fig. 7-25