Nice MhouseKit RM30R FE, Instructions And Warnings For Installation And Use

Page: 28 / 60

English
13 – English
2
sec.
ON OFF
01 02
8
sec.
New
I - - - - - - - - - - - - - - - - - - max 15 sec. - - - - - - - - - - - - - - - - ->I I- - - - - - max 60 sec. - - - - - - ->I
03
Paragraph 7.9.1
01 02 03 04 05
04
2
sec.
ON OFF
Note – When performing the procedure, at any time you can cancel it by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not
press any key and wait 60 seconds for the motor to perform 6 movements.
7.10 - Locking and unlocking the memory
This procedure allows you to lock or unlock the memory to prevent accidental memorisation of other transmitters not
included in the system.
Before starting the procedure, bring the shutter to the midpoint of its stroke.
01. Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the
s
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03.
Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the
s
and
t
keys pressed simultaneously and wait for the motor to perform 2 movements. Upon completion, release the keys.
05. • To unlock the memory: Keep the
s
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
• To unlock the memory: Keep the
t
key pressed and wait for the motor to perform 5 movements. Upon completion, release the key.
04
2
05
05
5
sec.
5
sec.
5
sec.
3
5
5
sec.
01 03 02
5
sec.
2 3
5
sec.
3
Note
– When performing the procedure, at any time you can cancel it by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not
press any key and wait 60 seconds for the motor to perform 6 movements.
MISCELLANEOUS INSTRUCTIONS
PHASE 8
8.1 - INSTALLING THE WALL MOUNT FOR TRANSMIT-
TER STX1
The provided transmitter has an accessory wall mount ( fig. 26 ). If the wall
is smooth and stable, use the provided adhesive, otherwise use the pro -
vided anchor bolt and plug.
8.2 - REPLACING THE TRANSMITTER BATTERY
To check the battery charge, press any button and check the led.
– If the led turns on only very briefly, the battery charge is low. If this is the
case, to send the command anyway, try holding the button down for at
least half a second.
– If the led fades and the transmitter turns off, the battery is exhausted
and will not complete the command or wait for the automation’s re-
sponse. If this is the case, replace the battery ( fig. 27, use a CR2032
lithium battery).
26