© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
46
APPLIANCES
Vacuums
Central cleaning systems make cleanup a snap, leaving you with more time to do what you enjoy. Your central
vacuum removes dirt and debris inside of your coach. The central vacuum includes tools to e
ff
ectively and
e
ffi
ciently clean all surfaces of your coach, including carpets, tile, furniture, window treatments, and more.
RoadVac by InterVac Central Vacuum Operation
(Model: CS-RM)
This article provides basic operation instructions for a RoadVac by InterVac Central Vacuum system (Model: CS-RM).
Operating The Vacuum
To operate the vacuum, make sure 120 volt power is
being supplied to the vacuum outlet. The vacuum must
be plugged in, and the power switch must be in the OFF
position when using the remote control on the pistol grip.
The vacuum will only turn ON when the Remote Control
Pistol Grip button has been pressed or when the switch
on the vacuum has been turned ON.
Pressing the Pistol Grip button for less than a second will
turn the vacuum ON or OFF. Do not hold down the button,
as it will greatly reduce battery life. When the Pistol
Grip Transmitter button is held down continuously, it will
continue to transmit for 9 seconds, and then turn OFF.
If the performance (range) in which the Pistol Grip
functions away from the receiver has reduced, replace the
battery to correct the issues. Note: Replacing the battery
may require the Pistol Grip Remote to be reprogrammed.
Replacement bag: Part #Y11 high filtration 5-layer fiber bag
1. Remove the front panel on the vacuum cleaner by
sliding the latch/lock and removing the front panel
with dust bag attached.
2. Remove full bag and discard.
3. Notice: The #Y11 double-sided bag has two openings.
The collar which attaches to the back of the vacuum
chamber is clearly marked “Push this collar over pipe
in the back of the vacuum chamber first.”
4. Hold the dust bag by the edges of the cardboard
in your hand. Push onto the pipe in the back of the
chamber holding at about a 45 degree angle, and
then push down the lower part of the collar against
the back wall until flush.
5. Push the front cardboard collar of the dust bag all the
way over the pipe on the front panel.
6. Slide the front panel into the small slots on the side
of the vacuum’s frame. Ensure dust bag is completely
inside compartment, then push it into the frame until
the lock/latch clicks into place.
Replacing The Vacuum
Double-Collar Bag
Changing The Motor Filter
Replacement: Part #Y22
1. Remove the front panel with dust bag.
2. Inside the vacuum chamber, you will see the filter with
the arrow pointing towards the back wall. Replace
the filter with a new or cleaned filter, with the arrow
pointing towards the back wall.
3. If the filter is dirty, you can wash it by hand in a mild
soap solution. Do NOT clean in washing machine. Let
filter dry completely before reusing.
Source(s): InterVac CS Series Installation and Operating Manual
Product(s): InterVac Central Vac System
(Model: CS-RM, Newmar Part Number: 142013)
Summary of Contents for Canyon Star 2021
Page 1: ...2021 sm ...