Newland NLS-EM20-EX, User Manual

Page: 30 / 187

Startup settings
Serial trigger command
When the reading mode is set to level trigger mode, it supports the serial communication command "Start reading" command to trigger the reading, the scanner reading successfully or reaching Read once
Code timeout Or end the reading after receiving the "stop reading" command.
•
Prohibited: Do not use serial trigger commands
Enable: use serial trigger command in level trigger code reading mode
•
* * 【Prohibited】
【Enable】
Modify the start reading instruction
Start the code reading command to simulate the key press. Instruction support 1 To 10 Characters, the range of characters is 1 To 0xFF . The first character cannot be'? '
(which is 0x3F) .
The default command is: < SOH> T <EOT>
【Modify start reading instruction】
Modify the stop reading instruction
The stop reading command can simulate the release of the key. Instruction support 1 To 10 Characters, the range of characters is 1 To 0xFF . The first character cannot be'? ' (which is 0x3F ).
The default command is: < SOH> P <EOT>
【Modify stop reading instruction】
20