Newland NLS-EM20-EX, User Manual

Page: 167 / 187

Startup settings
Chapter 9 Batch Processing Settings
Introduction
When multiple settings are required to read the device, it may be cumbersome to set one by one. At this time, we can save all the information that needs to be set as a barcode information, and the device will read
After taking the barcode, multiple settings can be completed.
The following are the guidelines for batch processing:
1 , The format of each command in the batch command is c parameter.
2 , Commands end with a semicolon, please note that there can be no spaces between each command.
3 , This command can be made into a barcode supported by any scanner in the coding software, and a QR code is recommended.
For example: turn on the lights (command: ILLSCN1 ), reading code in induction mode (command: SCNMOD2 ), one reading timeout time 2 second
(command: ORTSET2000 ), the batch command content is as follows (@ indicates that the command needs to be stored ):
@ILLSCN1;SCNMOD2;ORTSET2000;I25ENA0;
Read when you need to set " Start batch setting " , And then read the prepared batch code to complete the setting.
[Start batch setting]
157
Exit settings