Newland NLS-EM20-EX, User Manual, Page: 168 / 187

Startup settings
Generate batch instructions
A batch command can contain many individual commands. Each individual command is separated by a semicolon.
Command structure: command (+setting information)
A total of 3 Set command form
1 , Setting syntax 1 :command
The most commands in this form are the setting commands that can be completed in one setting without using data codes.
E.g:
Set the baud rate 38400bps The command is @ 232BAD6
The command to set automatic code reading is @ SCNMOD2
2 , Setting syntax 2 : C number
This form of command is used to set the value of some parameters. These parameters include: barcode reading maximum and minimum length setting, one reading timeout setting, same reading delay
Late setting, sensitivity setting, etc.
E.g:
Set the time of one reading delay as 3000 The command in milliseconds is: @ ORTSET3000
3 , Setting syntax 3 : C hexadecimal number
This form of command can be used to set custom prefix, custom suffix, terminator suffix, CodeID Wait.
Note: Every two hexadecimal characters in the command represent a character to be set.
E.g:
Set the custom prefix to "J" The command is: @ CPRSET4A
Set up Code128 of CodeID for" j "The command is: @ CID0026A
158