Newland NLS-EM20-EX, User Manual

Page: 131 / 187

Startup settings
Chapter 7 Data Format Editing
Introduction
You can use the data format editing function to change the output data of the scanner. For example, you can use the data format editing function to insert in a specific position of the barcode data
character.
Normally, when you scan a barcode, it will be output automatically. But when creating a data format, you must use the "send" command (send command) to allow the data format editing function
Can output data.
A total of four data formats can be set, namely the data format 0 ,Data Format 1 ,Data Format 2 ,Data Format 3 , The four data formats can be set separately according to actual needs. It can be used
correctly after setting. The data format includes the application range of the data format (such as barcode type, barcode length) and data editing commands. Be aware
When the barcode read does not match the data format used, the scanner will emit an error tone (if it is turned on " Data format does not match error sound").
When editing the data format, the maximum total length of all data format configurations is 2048 byte.
The data format editing function is disabled by default, and the user needs to enable this function before using it. There are two ways to add data format: one is through EasySet The software is configured,
and the second is to read the setting code.
After the user changes the data format settings, read the "factory default data format" setting code to clear all formats and restore the default settings.
* * 【Factory default data format】
121
Exit settings