6-10 Setting System Board Jumpers
Denying Access to CMOS Setup
In special cases, you may want to deny the user access to
CMOS setup. In this case you must change the jumper from
its default position. Use the following procedure to change
the jumper setting.
1.
Power off the system and unplug any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2.
Remove the system unit cover (see “Removing the
System Unit Cover” in Chapter 5).
3.
Locate the CMOS Setup Access jumper on the system
board (see “Locating System Board Jumpers” in the
previous subsection).
You may have to remove any installed expansion boards
to access the jumpers (see “Removing Expansion
Boards” in Chapter 5).
4.
Remove the jumper block from pins 5-6 and set it on
pins 4-5.
Summary of Contents for POWERMATE PROFESSIONAL PII
Page 12: ...xii Contents ...