6-8 Setting System Board Jumpers
Clearing CMOS
If you want to return your system to the factory default
settings, use the following procedure to clear CMOS to the
default factory settings.
!
CAUTION:
Clearing CMOS changes your setup configuration
including hard disk settings.
1.
Power off the system and unplug any peripherals.
!
WARNING
The system power must be off before removing the
cover and changing a jumper setting.
2.
Remove the system unit cover (see “Removing the
System Unit Cover in Chapter 5).
3.
Locate the CMOS Clear jumper on the system board
(see “Locating System Board Jumpers” in the previous
subsection). The default setting for this jumper is pins
5-6 (keep CMOS settings).
You may have to remove any installed expansion
boards to access the jumpers (see “Removing
Expansion Boards” in Chapter 5).
4.
Remove the jumper block from pins 4-5 and set it on
pins 5-6.
Summary of Contents for POWERMATE PROFESSIONAL PII
Page 12: ...xii Contents ...
