NEC POWERMATE ES Series, Service And Reference Manual

Page: 61 / 132

Disassembly and Reassembly 3-13
8. Slide the device out of the bracket.
9. Install a replacement device in the bracket.
Install a 5 1/4-inch device in the system as follows.
1.
Slide the replacement device through the front bezel and into the device bracket until the
device is flush to the bracket.
2.
Fasten the device to the bracket with the previously removed top screw (
B
).
3. Press the bracket lock on the side of the device bracket and raise the bracket up until it is
perpendicular to the chassis.
4.
Fasten the bottom of the device to the bracket with the two previously removed bottom
screws (
D ).
5.
Lower the device bracket halfway. Plug the signal cable and power cable into their
respective connectors on the device. As appropriate, plug the audio cable into the device
and connector CDIN on the system board.
Note
Be sure to use the short power cable to connect to the device. The long power cord
must be used for the hard drive.
6.
Lower the device bracket all the way down until it locks in place on the chassis.
As you lower the device bracket, ensure that all cables are out of the
way, are not pinched, and are folded correctly.
7.
Replace the system cover (see “Removing the System Cover” earlier in this section).
Diskette Drive Removal
Remove the 3 1/2-inch diskette drive as follows.
1. Remove the system cover (see ”Removing the System Cover” earlier in this section).
2.
Unplug the diskette cable from the drive as follows (see the following figure).
!
Release the brown cable retainer connector on the drive by gently pulling up each end
of the retainer until the cable releases.
! Remove the cable from the drive connector.
3.
Remove the screw securing the drive bracket to the chassis.
4. Lift the back end of the bracket up slightly to clear the tabs on the front panel, then slide the
bracket and drive towards the rear of the chassis and out of the chassis.