NEC POWERMATE ES Series, Service And Reference Manual

Page: 60 / 132

3-12 Disassembly and Reassembly
5 1/4-Inch Device Removal
Remove a 5 1/4-inch device from the system as follows.
1. Remove the cover (see “Removing the Cover” earlier in this section).
2.
While pressing on the device bracket lock, raise the bracket up enough to access the device
cables.
Unplugging the 5 1/4-Inch Device Cables
A – Audio Cable C – Signal Cable
B – Power Cable D – Device Bracket Lock
3. Tag and unplug the signal and power cables connected to the device. If the device is a
CD-ROM or DVD-ROM, tag and unplug the audio cable from connector CDIN.
4.
Raise up the device bracket (
A
) until it is vertical to the chassis (see the following figure).
5. Remove the top screw ( B ) securing the device ( C ) to the bracket.
6.
Remove the two bottom screws (
D
) securing the device to the bracket.
7. Lower the device bracket until it latches in place.
Releasing the 5 1/4-Inch Device
A – Device Bracket C – Device
B – Top Screw D – Bottom Screw (2)