NEC PowerMate 2000 Series, Service And Reference Manual, Page: 74 / 175

3-4 Disassembly and Reassembly
5. Carefully unplug the hard drive interface cable from the hard drive (see the
following figure).
!
Do not pull on the interface cable. Evenly pull on the connector at the
end of the interface cable until it releases from the hard drive connector.
!
Note the four pins on the right end of the hard drive connector. These
pins are for setting the drive configuration (factory set as master, no
jumper installed). Do not connect the interface cable connector over the
four pins during reassembly.
6.
Grasp the pull tab on the hard drive and carefully pull on it to remove the
drive from the drive bay.
Removing the Hard Drive
A – Interface Cable C – Hard Drive
B – Pull Tab
7.
Remove the hard drive from the system unit.
Note
:
If the pull tab is broken off and you are unable to
remove the hard drive, see “Hard Drive Bay and Drive
Removal” later in this section.