![background image](http://html.mh-extra.com/html/nec/express5800-120li/express5800-120li_user-manual_251168098.webp)
4-32 Configuring Your Server
Enabling RAID Feature
To configure a hard disk drive as RAID drive, change setting of RAID configuration jumper switch
on mother board.
NOTE:
The factory-set value is to use the hard disk drive as a single
disk drive.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
■
Do not disassemble, repair, or alter the server.
■
Do not remove the lithium battery.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
■
Make sure to complete board installation.
■
Do not install the server on a rack with leaving covers removed.
■
Do not pinch your finger with mechanical components.
■
Note high temperature.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the rack.
Summary of Contents for Express5800 120Li
