NEC Express5800 120Li, User Manual

Page: 153 / 344

Installing and Using Utilities 6-9
NEC EXPRESSBUILDER for DOS-based with Remote Console
This subsection describes the procedures for using NEC EXPRESSBUILDER for DOS-based with
remote console.
NEC EXPRESSBUILDER contains the remote console feature that allows the system administrator
to set up the server from the management workstation (management PC) via the network or the
server's COM B (serial) port.
IMPORTANT:
„
Do not use this feature on any other computer than the server, or
on any other server obtained without the NEC
EXPRESSBUILDER. Doing so may cause a failure of the server.
„
To use the remote console feature, a floppy disk containing a
configuration information file named "CSL_LESS.CFG" must be
inserted in the floppy disk drive. If "CSL_LESS.CFG" is not found
in floppy disk, no menu is displayed on the management PC.
„
If you fail to configure the disk array controller N8103-80F or 81F
from the remote console, try again using the server console.
„
The system may fail to operate with the transfer rate of 115.2 Kbps
for serial console redirection. Specify any other transfer rate than
115.2 Kbps.