NEC Express5800 120Li, User Manual

Page: 58 / 344

3-4 Setting Up Your Server
SELECTING SERVER SITE
Read the following precautions before selecting a suitable site for your server. The following
describes installation of the server and connections to the server.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
pages 1-3 to 1-8 for details.
■
Never attempt to lift the server with two or less persons.
■
Do not install the server in any place other than specified.
■
Do not use the server in a place with corrosive gas in presence.
The following figure illustrates a site suitable for installing the server.
* It is recommended that the
server should be used in a
room where temperature is in
the range between 15 to 25ºC.
Close enough to connect
the mouse and the display.
Install the server on the
floor or rigid, flat desk.
Open the stabilizers
to secure the server.
Place having a space enough to fully
open the front door (The front door
extrudes about 35 mm from the left
side of the server when fully opened.)
Room that satisfies the following conditions: *
<While operating> <While halting>
Temperature: 10 to 35ºC 5 to 40ºC
Humidity: 20 to 80% 10 to 80%
Temperature gradient: ±10ºC/h ±15ºC/h
Atmosphere (hpa): 749 to 1040 749 to 1040 hpa
100 to 120 Vac/200 to
240 Vac parallel bi-
polar wall power outlet
with the ground line.
Wall outlet to
connect the
supplied power
cord.
UPS to prevent momentary
voltage drop due to power
failure or lightning *
* Optional. UPS is
recommended for best
use of features of server.
Allow clearance of at
least 150 mm in front of
and rear of the server.