NEC Express5800 120Li, User Manual

Page: 154 / 344

6-10 Installing and Using Utilities
Starting
The following two methods are available to start the server.
„
Running NEC EXPRESSBUILDER from the management PC via LAN
„
Running NEC EXPRESSBUILDER from the management PC via direct connection
(COM B)
For the procedure for starting NEC EXPRESSBUILDER for DOS-based with Remote Console, see
"NEC DianaScope".
IMPORTANT:
„
Do not change the boot device order in BOOT menu in BIOS
SETUP. NEC EXPRESSBUILDER cannot be used if the DVD-
ROM drive is not the first device to launch the system.
„
To use the remote console feature, a floppy disk containing a
configuration information file must be inserted in the floppy disk
drive. You can create a configuration information file by using
System Management feature in the Tools menu or by NEC
DianaScope Configuration menu. The configuration information
file must be named as "CSL_LESS.CFG" and stored in the root
directory of the floppy disk.
NOTE: The following items of BIOS setup information will be set as
shown below.
„
LAN Controller: [Enabled]
„
Serial Port A: [Enabled]
Base I/O Address: [3F8]
Interrupt: [IRQ 4]
„
Serial Port B: [Enabled]
Base I/O Address: [2F8]
Interrupt: [IRQ 3]
„
BIOS Redirection Port: [Serial B]
„
Baud Rate: [19.2K]
„
Flow Control: [CTS/RTS]
„
Console Type: [PC ANSI]