NEC 140He, User Manual

Page: 223 / 360

8-19
Error
code
Error message Recommended Action
0B80 BMC Memory Test Failed.
0B81 BMC Firmware Code Area CRC check failed.
0B82 BMC core hardware failure.
0B83 BMC IBF or OBF check failed.
0B8A BMC SEL area full.
0B8B BMC progress check timeout.
0B8C BMC command access failed.
0B8D Could not redirect the console - BMC Busy -
0B8E Could not redirect the console - BMC Error -
0B8F Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
Turn off the power once and then on again to start the server. If
the error cannot be corrected, contact your service
representative.
0B92 Internal Use Area of BMC FRU corrupted. All the commands and functions other than the FRU command
and the EMP function can be used. This is not a fatal error.
Turn off the power once and then on again to restart the server.
If the error cannot be corrected, contact your service
representative.
0B93 BMC SDR Repository empty. Turn off the power once and then on again to restart the server.
If the error cannot be corrected, contact your service
representative.
0B94 IPMB signal lines do not respond. All the functions other than the function of accessing to SMC
through IPMB can be used. This is not a fatal error. Turn off the
power once and then on again to restart the server. If the error
cannot be corrected, contact your service representative.
0B95 BMC FRU device failure. All the commands and functions other than the FRU command
and the EMP function can be used. This is not a fatal error.
Turn off the power once and then on again to restart the server.
If the error cannot be corrected, contact your service
representative.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A BMC not responding.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
Turn off the power once and then on again to start the server. If
the error cannot be corrected, contact your service
representative.
0BB0 SMBIOS - SROM data read error.
0BB1 SMBIOS - SROM data checksum bad.
Contact your service representative.
0BC0 POST detected startup failure of 1st
Processor.
0BC1 POST detected startup failure of 2nd
Processor.
0BC2 POST detected startup failure of 3rd
Processor.
0BC3 POST detected startup failure of 4th
Processor.
Contact your service representative to replace the processor.