NEC 140He, User Manual

Page: 305 / 360

9-47
5.
Fully open the levers at both ends of the socket (1) and remove the socket cover.
IMPORTANT:
„ To avoid damaging the lever, do not apply an excess force to the lever.
„ Keep the removed blank cover for future use.
6.
Push the DIMM straight into the socket (2).
NOTE:
Make sure of the orientation of DIMM. The terminal side of the DIMM has a
cut-out to prevent incorrect insertion.
The levers automatically close when the DIMM is inserted into the socket (3).
IMPORTANT:
Always install the DIMMs in pair. Two DIMMs must be of the same
specification. DIMM specification is shown on the label attached to the DIMM as follows:
Example: Frequency of 400 MHz, buffered, capacity of 1GB, row
address of 14 bits, column address of 11 bits, and
single rank
2-400 / B / 1024 / R14 C11 S
Single rank
Column address
Row address
Capacity
Buffered / Registered
Frequency
7.
Install the memory board back into the chassis slot.
8.
Install the memory slot cover.
9.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error messages listed in
Chapter 8.
10.
Start the SETUP and select [Advanced]
→
[Memory Configuration] to verify that the installed DIMM shows
the status "Normal". (See Chapter 4 for details.)
11.
Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See Chapter 4 for details.
12.
If Windows Server 2003 or Windows 2000 is in use, set the paging file size to the recommended value (total
memory size * 1.5) or a greater value. See Chapter 5 for details.