NEC 140He, User Manual

Page: 245 / 360

8-41
Problems with Express Setup
Express Setup can not be used
→
Express Setup does not support the installation of Microsoft Windows Server 2003 x64 Editions.
If you want to perform re-setup, see Appendix D and perform "Manual Setup".
Following message appeared when you tried to install Express Setup to the hard disk that has smaller capacity
than the specified partition size:
The specified partition size has exceeded the capacity of the hard disk.
The setup created the partition at the maximum size that can be reserved on the hard disk.
Setup will continue the process.
OK
→
It is not an abnormal condition. Press Enter to continue the installation.
The message can not be displayed correctly when copying the files from CD-ROM or checking CD-ROM:
→
Press
R
. When any messages appear again even if you press
R
, restart the Express Setup from the
beginning. In case the same result occurred after the restart of installation, contact your service
representative and ask them to check the CD-ROM drive.
Express Setup terminated and asks to input setup information.
→
There are some errors on the specified setup information.
Follow the instruction to input the correct value. It is not necessary to cancel the installation. On
Windows 2000, you might be asked to press Enter again after the last reboot of the setup.
[Complete] appears on the [Role of Computer] screen.
→
If you click [Complete] here, the setup will select the default value of Express Setup for the later
specification to continue the process.
<The Default Value for Windows 2000>
The specification of network protocol
Protocol : TCP/IP[DHCP Specified]
Service : Select sharing Microsoft network files and printer.
Client : Microsoft network client.
Component : SNMP, IIS (Excluding Professional/Windows Server 2003)
Application : ESMPRO Agent
Power Console Plus (When disk array system)
[Complete] does not appear on [Role of Computer] screen.
→
[Complete] does not appear if the setup information file that has already been created is loaded.
→
[Complete] appears only when you first entered the [Role of Computer] screen.
Once you go to the next screen from [Role of Computer], the [Complete] will not appear even if you enter
[Back] to go back to the [Role of Computer] screen.
Select [Use Existing Array] at [New/Existing RAID Configuration], but the operating system is installed in the
whole area of the disk.
→
Is there any other partition than the partition to re-use (excluding maintenance area)? If no other partition
than the one to re-use exist, the setup will reserve the whole area of the disk to install Windows 2000.