Users Guide ValueJet 1614
13
AP-75790 Rev 1.4 -22/02/2011,
Pay attention to the following points, while handling the power cables.
±
Do not do anything forcefully on the power cables.
±
Do not keep heavy objects on the power cables.
±
Do not bend, twist or pull the power cables by force.
±
Do not route the power cables near heating appliances.
Verify that no foreign substances such as dust are stuck on the power plugs. If you have controlled this,
make sure that the power plugs are firmly inserted to the edge of the power socket.
Mishandling of the power cables could lead to a fire.
Be careful that your fingers are not caught when opening or closing the media cover or front cover.
Do not operate the media set lever during printer initialization. If the carriage portion and the pressure
roller portion touch each other, there is a possibility that the printer may break down.
Do not touch the media guide during printing. It is hot and may cause burns.
Do not touch the media feed slot, platen or media guide while heaters are operating. They are hot and
may cause burns.
Do not use volatile solvents such as thinner, benzene, or alcohol. These could damage the paint.
Be careful that moisture does not enter the printer. There is a possibility that the electric circuits inside
the printer might get short circuited.
Do not open covers attached with screws under any circumstance. This could cause an electric shock or
printer breakdown.
While cleaning with the wiper
±
Do not touch the cleaning wiper and head cap unit.
Head cleaning may not be operated correctly because of the grease attached.
±
Make sure to wipe the print head with a dry poly-knit wiper.
Do not make the main body of the printer slanting or place it in a vertical position or do not keep the
printer upside down. There is a possibility that ink inside the printer may leak. Moreover, normal
operation after shifting (to these positions) cannot be guaranteed.
Unpacking, transporting and installing the printer to the installation place should be done by 4 or more
persons
Move the printer maintaining it in a horizontal position.
Do not make the main body of the printer slanting or place it in a vertical position, nor keep the printer
upside down. There is a possibility that the ink inside the printer may leak. Moreover, normal operation
after shifting to these positions cannot be guaranteed.
While taking out the printer from the container box, make sure to remove the vinyl sheet and hold the
handles on the printer side. If the printer is lifted with the vinyl sheet attached, there is a possibility that
the printer might fall and might be damaged.
While installing the stand, be sure to switch OFF the printer power and to pull out the power plugs. It
could lead to an electric shock.
If the printer is not used for a longer period, make sure to pull out the power plugs from the power
sockets for safety reasons.
Make sure to connect an earth wire to the earth connection which meets the following standards:
±
Earth terminal of power socket
±
Earth wire with copper plate which is buried at 650 mm or more, deep in the ground.
Set the roll media on an even surface such as a desk etc. If the roll media is set in such a way that the
scroller is standing vertical, there is a possibility that the scroller might get damaged.
When printing is finished, the media guide is at high temperature. Wait until the media guide cools off.
All manuals and user guides at all-guides.com
