Spitfire 100 Extreme series printers Users Guide
168
AP-75194 - Rev. 2.2
(10) Ink is not used though you performed initial ink charge.
N°
Possible cause
Solutions
1
The ink cassette is cold or frozen.
Leave the ink cassette in normal temperature
for at least three hours, and perform cleaning
a few times.
2
You switched off the printer during the initial ink
charging.
Switch on the printer to continue the initial ink
charging.
3
The printer rarely prints correctly only after initial ink
charging.
Perform cleaning a few times and check
again.
4
Pumps or tubings are blocked
Replace the tubings.
5
There is a leak, no vacuum, no air suction.
Find the leak and repair it.
(11) The media is off or damaged when loading it.
Notes
Remove the jammed or damaged media, referring to "When media jams occur".
N°
Possible cause
Solutions
1
You did not use recommended media.
Use recommended media.
2
The loading position of the media is not correct.
Load the media correctly.
3
Foreign material, such a piece of media, is attached
to the pressure rollers.
Clean the pressure rollers.
4
You used the printer in direct sunlight or other
locations not appropriate for the specified
environment.
Use the printer in the specified environment.
5
You loaded sheet media into the printer.
Set the CutSize setting to Length or Width.
6
You used folded, creased, or curled media.
Replace with new media.
7
Check the media for curling or lift off.
Use the recommended media.
When using media other than recommended
media, set the following items in the media
setting menu.
Media
HeadHeight
Stiff
(12) Media is damaged during media Initial.
Notes
Remove the jammed or damaged media.
N°
Possible cause
Solutions
1
You did not use recommended media.
Use recommended media.
2
The loading position of the media is not correct.
Load the media correctly.
3
You did not load the media straight into the printer.
Load the media straight into the printer.
4
Foreign material, such a piece of media, is attached
to the pressure rollers.
Clean the pressure rollers.
5
You used the printer in a location with air conditioner
or other location not appropriate for the specified
environment.
Use the printer in the specified environment.
6
You loaded sheet media into the printer.
Set the CutSize setting to Length or Width.
7
You used media folded, creased, damaged, torn,
curled.
Replace the media.
Summary of Contents for Spitfire 100 Extreme
