MUTOH Kona 1400, User Manual

Page: 89 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
AP-75370 - Revision 1.1 89
4
Step 4:
Weed out the boxes as shown below, check the patterns and determine which of
them gives best quality. Especially look for good quality of the corners and easy
weeding.
Step 5:
Point the knife over the optimum knife offset using the left-right arrow keys and
confirm with . Use the up-down arrows to move the media forward or backwards
to show the test pattern once more.
The offset value is larger than the
optimum knife offset
The offset value is smaller than the op-
timum knife offset
In this case, a square corner is cut as
follows:
The cutting direction is indicated by the
arrow. The corners are not well formed.
The cutter cuts too far in the angular
points.
In this case, a square corner is cut as
follows:
The cutting direction is indicated by the
arrow. The corners are not well formed.
The cutter did not cut far enough in the
angular points.
Note

In case none of the squares shows a good offset, look for the best square,
select this one and perform a new test cut.