MUTOH Kona 1400, User Manual

Page: 101 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
AP-75370 - Revision 1.1 101
4
Optimize
When calibrating the EPOS, the X and Y distance is measured between the pen and the
laser. These values are used when contour cutting.
Normally, these values are correct, but in rare cases a shift could happen. To delete this shift,
you can optimize the offset distances between the pen and the laser.
These distances are counted up with the calibrated values.
When performing a new EPOS calibration, the optimize values are being reset to 0.
Perform an EPOS optimization as follows:

Settings

Epos

Optimize

Press
Distance X
or
Distance Y
to adjust the value.

Add an offset to the EPOS and click