MUTOH Kona 1400, User Manual

Page: 159 / 218

User’s Guide Kona / Kona apparel cutting plotter
Contour cutting
AP-75370 - Revision 1.1 159
6
When the cutter establishes a slight difference between the thicknesses of the frame in one or
more corners, a re-measuring is performed at the respective side of the frame but slightly
higher or lower. If there is still dissimilarity, a warning message is displayed on the panel and
a cross is cut in the lower right corner.
Refer to
Contourcutting errors and warnings (ID 6201-6271) on page 197
Situation 2 = Both sides detected (4 points)
Situation 3
1st scan > both sides detected (2 points)
feed of media to start second fast scan
2nd scan > bottom and side of frame detected (4 points)
1
2
3
4
s
c
an
1
s c an 2
s c an 1
1’
2 ’
3 ’
4 ’
1
2
Note

The same principle of scanning is also used on the top and centre of the
bounding box. Due to the use of this measurement system it is possible to
measure bounding boxes with a small print step error.