MUTOH Kona 1400, User Manual

Page: 114 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
114 AP-75370 - Revision 1.1
Page Mode
The page mode determines the cutter’s reaction to a PAGE command sent by the cutting
software. The PAGE command is used to relocate the origin after a job is finished and can
take control remotely of the cutter’s automatic sheet-off feature. Sheeting-off automatically,
without user intervention.
A page-command looks like this: “PG;” or “PGn;” with “n” a number in millimetres.
If the PAGE command “PG;” is sent, the cutter automatically sheets of regardless of the Page
mode, minimizing the loss of media.
If the PAGE command “PGn;” is sent, the number mentioned after the PG command is
interpreted differently, depending on the page mode you have chosen:
Page Mode 0
The number after the page command is ignored. The media is cut 5 mm (0.2”) after the latest
down-vector. The new cutting limit is located 0.5 (0.2”) from the lower media border.
Page Mode 1
The new origin is located “n” millimetres beyond the last down-vector that was sent.
Page Mode 2
The new origin is located “n” millimetres beyond the previous origin position.
Step 1:
Press the following buttons in order:

Settings

Next page

Page mode
“PGn” is sent (n is a number in mm).
A: Original origin
B: End point last vector
C: New origin with Page Mode 1
D: New origin with Page Mode 2
Note

Pressing opens a help screen. To close the screen, press the screen.