MUTOH Kona 1400, User Manual

Page: 129 / 218

User’s Guide Kona / Kona apparel cutting plotter
Operation panel
AP-75370 - Revision 1.1 129
4
When you want to start a contour cutting job without using the automatic alignment option, the
manual
mode needs to be chosen. This could be useful when you have loaded very reflective
media which cannot be detected by the cutter. Start a
manual
contour cutting job as follows:
Step 1:
Press the following buttons in order:

Actions

Contour Cut

Manual

Manual
Step 2:
Set the exact length and width of the bounding box.
Step 3:
Set the roll
direction
.

Non-reverse: When standing in front of the cutter, the data sent should not be
rotated.

Reverse: When standing in front of the cutter, the data sent should be rotated.
Step 4:
Press
start
.
Step 5:
Move the penhead using the jog keys until the knife point is positioned above P1
and press OK when done. Then select P2 - P3 - P4.
Step 6:
The knife will pause near point P1
Step 7:
Send the relative (NOT absolute) plot data to the cutter to start the job.
X Length
Y Width
P1
P3 P2
P4