MUTOH Kona 1400, User Manual

Page: 191 / 218

191 AP-75370 - Revision 1.1
User’s Guide Kona / Kona apparel cutting plotter
Troubleshooting
9.1.8 Some parts of the design are not well cut.

Check whether the knife tip is not clogged with material residues.

Examine the knife blade with a magnifier to see if the tip is not damaged or broken.

Perform the offset adjustment routine to check cutting quality.

Perform the test cut and check its quality.

Perform the EPOS alignment test.
9.1.9 The output is 2,5 x too large or 2,5 x too small

The cutter is using the wrong step adjust. Please refer to chapter 4 “Program Step”, to correct the step adjust and try again. As an alternative
solution, you can also choose to change the step adjust in your software. Both settings should be matched to each other.