MUTOH Kona 1400, User Manual

Page: 189 / 218

189 AP-75370 - Revision 1.1
User’s Guide Kona / Kona apparel cutting plotter
Troubleshooting
9.1.2 Beeping codes: My Kona / Kona apparel is making a beeping sound once in a while.
The Kona / Kona apparel have different kinds of beeping sets. Each telling something else.
Below you find a small overview of when the Kona / Kona apparel is making which sound.

2 short tunes = Start-up tune

Happens when the complete machine is started successfully.

9 short beeps

Happens after start-up, before the y movement starts

Happens after lever down before the media measurement starts

Never ending beeping tune

Happens when an error occurs.

In case of a fatal error, the tune can be stopped by pressing the screen. Restart the machine to continue working

Short beep = key tune

Happens when a key is touched (when enabled in the user interface)

2 short beeps will sound in case of entering an invalid value.

Beep tune of 1 sec

Happens when a toolswap request is received and the user needs to take some actions.

Happens when an Epos error is detected.
9.1.3 The USB connection disappears.
In case the Kona / Kona apparel is subject to static electricity, the USB connection can be abrupted. To make a new connection, pull out the USB cable
and reinsert it.
It is very important to install the anti static brushes to avoid these kind of problems.