KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
15
The serial number of the transmission gearbox is
stamped on the upper part of the gearbox, in the
area of compressor drive pulley, vertically under the
lifting eye nut.
The serial number of the pump drive reducer is
stamped on the casing at the side, on the lateral lid.
The serial number of the axle is stamped on the
case in the area of inlet flange on the left.
2.2 Brief data on construction and layout
K744R1, K744R2, K744R3 or K744R4 tractors are differentiated by design of the engine unit,
by a radiator unit.
K744R3 and K744R4 tractors have an increased weight due to installation of ballast.
Electrical equipment of tractors is fitted out with preparation for installation of the Glonass data
acquisition and storage system, which is located under the instrument panel.
When ordering tractors with the
“Installation of Glonass system” option
, the manufacturer
shall, in the regular mode, install this system, activate it, perform a test checkup of the
controlled parameters.
On the tractors, the possibility of installation of a rotation beacon is provided. The rotation
beacon is installed in the rear part of the cabin, on the left in the direction of tractor travel.For
installation, it is necessary to unscrew the plug, fix the beacon on the regular bracket, take off
the power cord and connect the rotation beacon. The beacon activation switch is located on the
ceiling panel of the cabin.
On the tractors, a four-stroke eight-cylinder V-shaped engine is installed:
