KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
35
During turns select the speed providing safe traffic.
IT IS PROHIBITED
to make a sharp turn at
the gear being higher than the first gear of the fourth mode.
In crossing dams, dikes and bridges, make sure of the possibility of driving and use only low
gears.
Before passing the route sections requiring motion on both driving axles (ascent, heavy places),
perform activation of the rear axle beforehand.
When working on slopes exercise caution, carefulness in tractor driving and meet the following
conditions:
do not shut off the engine and do not change gears modes on steep ascents and
descents;
during motion down the slope
IT IS PROHIBITED
to use coasting;
it is allowed to work across the slope (the slope angle shall not exceed 5°) only in modes
I...II and avoid sharp turns and passing obstacles.
Perform stream wading only after thorough preparation and inspection of the route of travel. It is
allowed to perform wading with the depth of no more than 0.8 m for K-744R1 tractors and 1.0 m
– for K-744R2, K-744R3, K-744R4 tractors.
Coupling to the tractor and mounting of agricultural machines and implements on the tractor
shall be carried out by persons operating such machines. The coupling worker who performs
mounting implements shall stay aside until full stop of the tractor and begin coupling (mounting)
only after driver’s signal.
During operation of the tractor with agricultural machines and implements observe the safety
rules set forth in the operating instruction for such machines or implements.
Approach the agricultural machines, implements or trailers on the tractor at the minimum gear
with the drain gate drive pedal being depressed incompletely having preliminarily issued a
sound signal.
After connection to the trailing implements and pumping of the hydraulic system, check the level
of oil in the hydraulic tank and, if necessary, refill it.
It is strictlyPROHIBITED
to stay under the agricultural implement being lifted
.
In case of long-term outage, do not leave the mounted agricultural implement in the lifted
position.
IT IS ABSOLUTELY PROHIBITED
to stay under the implement being lifted
.
During work with hydraulic agricultural machines and implements it is necessary to remember
that the maximum working pressure at the outlet of quick lock rupture devices is equal to no
more than 15.0 MPa (150 kgf/cm
2
).
