KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
65
– rear lights having three sections: extreme outer sections – turn indicator (orange) and
then
– stop signal (ruby), end marker (red);
– “Road-train” sign consisting of three lights with orange-colored diffusers installed on the
cabin;
– license plate illumination light installed on the bracket above the left wing of the tractor.
On the supporting beam of the rear left wing, a plug socket is installed for connection electrical
equipment of trailers.
A plug socket 12 V is installed under the cabin on the bottom to the right for connecting the
lighting fixture. A dome light with built-in switch is installed on the rear wall of the cabin.
During travelling over motor roads only front traffic headlights are uses, which have low and
high beam modes. In order to avoid dazzling of oncoming vehicles as well as vehicles moving
behind,
IT IS PROHIBITED
to switch on the front and rear service headlights during
transportation activities.In hooking up the tractor with trailer (semi-trailer), it is obligatory to
switch on the “Road-train” sign.
Lighting and signaling control shall be performed by the handle for switching-on of the lighting
and signaling instruments (see Fig.11) as well as by the switch of switch block (see Fig.12).
4.11 Engine preparation and start-up
4.11.1 Before engine start-up make sure that the levers of hydraulic distributor of the hydraulic
system of mounted implement are in the neutral position and the parking brake is engaged, the
engine shutdown handle is pushed in up to the stop. The gear change lever and the mode
change lever shall be in the “Neutral N” position. Set the lever of manual fuel feed into the
position corresponding to the minimum rotational speed of the engine crankshaft.
4.11.2 Perform the engine start-up in the following sequence:
– if necessary, fill the engine feed system with fuel. To this end, pump out the system
during 2...3 min by manual fuel boosting pump (it is located under the cabin, on the right,
in the area of vertical hinge pivot);
– turn on the battery master switch. In doing so, the indicator lamps 27 and 18 (see Fig.
1, 2, 3) or 27 and 44 (see Fig. 4) will come on, the glare of built-in indicator lamp 41 of the
engine oil pressure is possible, the indicatorlamps 8 and 10 are burning with flashing
light.
The burning of indicator lamps 1 and 2 is allowed.
– insert the key into the keylock switch of the starter and instruments;
– turn the key into the second position.
