![MTZ K-744R1 Operating Instruction Download Page 100](http://html1.mh-extra.com/html/mtz/k-744r1/k-744r1_operating-instruction_1853330100.webp)
KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
100
6.6.3 Order of work with vehicles
ATTENTION!
The road-train in the following sequence and composition: tractor, semi-
trailer (1
ПТС-9Б or ОЗПТ-8573) and trailer (ЗПТС-12Б or ОЗПТ-8572) is designed for
carriage of cargoes over all types of roads. Under unfavorable road conditions the
tractor hooks up only with one semi-trailer or trailer.
In using the tractor with other vehicles, fulfil the following additional requirements:
a) the load on tractor wheels shall not exceed the data indicated in Table 3;
b) all machines to be used for transportation of cargoes shall be equipped with pneumatic
or pneumatic-hydraulic brakes securing traffic safety;
c) the braking system of the trailing vehicle shall provide own deceleration of trailers with
cargo at the emergency braking with at least 5.5 m/s
2
.
The time from the moment of pressure drop at the connecting head level to 90% of the initial
value until the moment, at which the pressure in the trailing vehicle actuator being in the least
favorable conditions reaches 75% of the steady-state value with the control member being fully
operated, shall not exceed 0.4s;
d) the total weight of the load being conveyed including the trailer shall not exceed 36 t.
During motion of the tractor with all kinds of vehicles use the fuel feed pedal setting the manual
feed handle into the position securing taking-off of the tractor with the vehicle with allowance for
theload weight.
6.6.4 Work with power taking off (PTO)
Power take-off (PTO) is designed to transfer the engine power to the work tools of the machines
to be hooked up with the tractor.
PTO consists of a connecting clutch with valve, single-speed reducer with oil pump, front and
rear cardan shafts.
During operation fulfil the following requirements:
a) with the connecting clutch being disengaged the reducer with rear card shaft shall
admit barring by hand;
b) perform engagement of the connecting clutch on load with the steady-state pressure in
the gearbox hydraulic system being not less than 11 kgf/cm
2
.