KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
37
in case of a sudden stop of the tractor on
the surfaced portion of roadway, switch
on the alarm signaling. Such switching on
is performed by pressing the button, pos.
40, on the instrument panel (Fig. 1, 2,
3,4). In doing so, a reference lamp built
into the switch button will get alight;
trailer brakes shall be adjusted in accordance with the requirements set forth in the
operating instructions for trailers;
motion of the tractor train at maximum speed (up to 8.39 km/h) is allowed only on roads
with dry hard pavement;
in case of first signs of jack-knifing or skid of the road-train, release the brake pedal and
brake by means of the control handle for trailer brakes until jack-knifing or skid are
eliminated;
at the road-train parking, during loading (unloading) of trailers set the handle of manual
brake valve into the “pulled” position. Before the beginning of motion set the brake valve
handle into the “pushed” position;
in hooking up the tractor with vehicles having 12V equipment, it is necessary to replace
electrical lamps on the vehicles;
In driving with the vehicle:
periodically check the operability of trailer brakes braking it by the trailer brake control
handle;
IT IS PROHIBITED
to use the lever of manual fuel feed set the fuel feed lever into the
position of minimum fuel feed;
transportation of people on trailers is prohibited.
IT IS PROHIBITED
to work with the power take off without installation of protective
enclosures. In case of short-term stops for inspection of the implement, which is operated
with the power take off shaft, it is necessary to disengage the power take off shaft.
The connection and disconnection of the PTO reducer shaft to the slotted bushing of the
agricultural implement drive shall be performed with the engine being stopped.
do not leave the operating pre-starting heating system unattended;
When working on the tractor:
see for the readings of instruments and signal devices. The readings of instruments and
signaling
of indicator lamps shall correspond to the directives set forth in the “Controls”
section;
