KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
79
Rear working
lamps
Installation and connection
of the working lamp
Perform connection of the front traffic and service headlights, rear service lights, front and rear
lights, lateral turn repeaters and road-train sign according to the electrical schematic diagram
(see Appendix).
During installation of the lamp for license plates and “Road-train” sign use the grounding wires
from the SPTA kit connecting them according to the electrical diagram. Signal wire
– to the lamp
contact of the light, and “frame” wire (with round tip) – to the fastening bolt of the light housing.
5.1.3 Adjustment of head lights
Head illumination lamps (outer
– low beam, internal – high beam) are built into the boot. The
primary direction of the light fluxes is adjusted at the manufacturer-factory in accordance with
GOST R 41.48-2004. However in the course of operation, at the replacement of lamps, the
direction of light fluxes can change, which requires the necessity of additional adjustment of
headlamps.
In order to adjust the headlamp light, install the tractor on the even horizontal ground at the
distance of 5 m from the screen (wall). Adjust headlamps in sufficiently darkened conditions.
working headlamp
bracket
ceiling harness
headlamp
battery master switch
wire (for lights 8724)
connecting socket
cabin bracket