Cleaning centrifugal oil filter
and replacing filter sleeve
1.
Release screw (1) and remove.
2.
Remove clamp (3) and take off cover (2).
3.
Carefully remove rotor assemble (12) from
housing (5).
4.
Hold rotor assembly (12) firmly in position
with filter wrench and release knurled nut
(13).
5.
Take off rotor cap (12).
6.
Remove filter sleeve, stiffener plate and
sealing ring (10).
7.
Measure thickness of oil residues on filter
sleeve.
8.
If maximum layer thickness of oil residues
exceeds 30 mm, shorten maintenance in-
terval.
9.
Take off standpipe (11) from lower rotor
section (9).
10.
Wash hood (2), rotor cap (12), stiffener
plate, standpipe (11), rotor lower sec-
tion (9) and nozzles (7) with cold cleaner
and blow out with compressed air. Do not
use sharp-edged objects for cleaning.
11.
Check nozzles (7) for obstructions.
12.
Push standpipe (11) onto rotor lower sec-
tion (9).
13.
Insert the new filter sleeve with stiffener
plate in rotor cap (12) with the smooth sur-
face facing the rotor cap.
14.
Check sealing ring (10), fit new one if nec-
essary. Coat sealing ring with grease and
insert in groove of rotor cap (12).
15.
Place rotor cap (12) onto standpipe (11).
16.
Hold rotor assembly (12) firmly in position
with filter wrench and tighten curled nut
(13).
17.
Lubricate bearings of rotor assembly (12),
insert in housing (5) and check for ease of
movement.
18.
Check sealing ring (4), fit new one if neces-
sary. Fit sealing ring on housing (5).
19.
Fit hood (2).
20.
Tighten screw (1) by hand.
21.
Install clamp (3) and tighten with torque wrench to the specified torque.
Name
Size
Type
Lubricant
Value/Standard
Clamp
Tightening torque
8 Nm +1 Nm
22.
Tighten screw (1) with torque wrench to the specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
Tightening torque
5 Nm +2 Nm
MS150112/01E 2014-10
| Task Description | 161
TIM-ID: 0000038266 - 001
