MSA 10103219, Use And Maintenance Instructions

Page: 16 / 64

Page 16 © 2019 MSA
P/N 10103008
ENGLISH
DO NOT leave unattended loads on the Anchorage Connector.
DO NOT tie the Anchorage Connector in a knot.
It is essential for the safety of the user that if the product is re-sold outside the original country of destination the reseller shall provide instructions and additional
relevant information for use, for maintenance, for periodic examination and for repair in the language of the country in which the product is to be used.
Failure to follow these warnings or misuse can cause serious personal injuries or death.
MAINTENANCE AND STORAGE
Anchorage Connectors are constructed from nylon/polyester webbing or galvanized steel wire rope. All load bearing hardware is Zinc plated alloy Steel. Strictly
adhere to the cleaning instructions in this section to prevent adverse effects on the materials used in the Anchorage Connector. Clean the Anchorage Connector
with a solution of water and mild laundry detergent. Dry hardware with a clean cloth and hang Anchorage Connector to air dry. Do not speed dry with heat.
Excessive accumulation of dirt, paint, or other foreign matter may prevent proper function of the Anchorage Connector, and in severe cases, weaken the webbing.
Questions concerning Anchorage Connector conditions for safe use and cleaning should be directed to MSA.
Equipment which is damaged or in need of maintenance must be tagged as “UNUSABLE” and removed from service. Corrective maintenance (other than cleaning)
and repair, such as replacement of elements, must be performed by the MSA factory. Do not attempt field repairs.
Store the Anchorage Connector in a cool, dry and clean place out of direct sunlight. Avoid areas where heat, moisture, light, oil, and chemicals or their vapours or
other degrading elements may be present. Equipment which is damaged or in need of maintenance should not be stored in the same area as usable equipment.
Heavily soiled, wet, or otherwise contaminated equipment should be properly maintained (e. g. dried and cleaned) prior to storage. Prior to using equipment which
has been stored for long periods of time, a formal inspection should be performed by a competent person.
Transport the Anchorage Connector in a package to protect it from cuts, moisture, chemicals and their vapours, extreme temperatures, and ultraviolet rays.
The maximum lifespan of the product is 10 years under condition that the product was not in use or very seldom in use and optimal storing conditions. However, the
primary indicator of fitness for use is the regular inspection of the product. Any product that does not pass inspection must be removed from service immediately
regardless of its age. The following factors reduce the performance of the product and its lifespan: incorrect storage, incorrect use, wear and tear, contact with
chemicals (acids and alkalis), exposure to high temperatures and UV radiation. More frequent inspections are required in these environments.