MROTEK PINE-16M, Configuration Manual

Page: 75 / 100

5.5 Configuring the Ethernet interface on remote inverse multiplexer
device
5-7
5.5 Configuring the Ethernet interface on remote
inverse multiplexer device
5.1.1 Configuring auto-negotiation function
Command Description
config
Enter the global configuration mode.
remote
0 <1-16> Enter the remote inverse multiplexer device configuration mode
interface eth 1
Enter the eth configuration mode of remote inverse multiplexer device
[no] autonegotiate
Configure auto-negotiation function.
show interface
Shows the configuration information
This command is only applicable for inverse multiplexer device with electrical interfaces, including PINE-
iE1 and PINE-8.
Example:
Mro-tek#
config
Mro-tek(config)#
remote
0 8
Mro-tek(config-remote/0/8)#
interface eth 1
Mro-tek(config-eth/0/8/1)#
autonegotiate
Mro-tek(config-eth/0/8/1)#
show interface
5.5.2 Shutting down and Enabling the Ethernet interface
Command Description
Config
Enter the global configuration mode.
remote
0 <1-16> Enter the remote inverse multiplexer device’s configuration mode.
interface eth 1
Enter the eth configuration mode of remote inverse multiplexer device.
Shutdown
Shut down the selected Ethernet interface.
No shutdown
Enable the selected Ethernet interface.
show interface
Shows the configuration information
This command is only applicable for inverse multiplexer device with electrical interfaces, including PINE-
iE1 and PINE-8.
Example:
Mro-tek#
config
Mro-tek(config)#
remote
0 8
Mro-tek(config-remote/0/8)#
interface eth 1
Mro-tek(config-eth/0/8/1)#
no shutdown