MROTEK PINE-16M, Configuration Manual

Page: 30 / 100

Configuration of the Ethernet interface of PINE-16M
4-14
4.5.7 Configure auto-MDI
To have the Ethernet interfaces to recognize the Ethernet cables Pin arrangement automatically (Cross /
Straight), enable the auto-MDI function. The auto-MDI function is disabled by default.
Command Description
config
Enter the global configuration mode
interface eth
<1-2> To Select a specific Ethernet interface of PINE-16M.
[no] automdi
Enable or disable the auto-MDI function
show interface
Shows the configuration information of the interface.
Mro-tek#
config
Mro-tek(config)#
interface eth
1
Mro-tek(config-eth/0/1)#
automdi
setup successfully!
Mro-tek(config-eth/0/1)#
4.5.8 Configuring ALS function of optical interface
The ALS (Automatic Laser Shutdown) function of the optical interface is effective only when the
transmission from laser is enabled. When RXLOS alarm occurs, the Fiber optic transceiver will deactivate
the Tx port. When RXLOS alarm is acknowledged, the Transceiver will activate Tx port. The ALS
function is enabled by default.
Command Description
config
Enter the global configuration mode.
interface fx-eth
<1-2> To Select a Fx-Ethernet interface-1 of PINE-16M.
als
(enable|disable) To enable/disable ALS function.
show interface
Show the configuration information of the interface.
Example:
Mro-tek#
config
Mro-tek(config)#
interface fx-eth
1
Mro-tek(config-fx-eth/0/1)#
als
enable
setup successfully!
Mro-tek(config-fx-eth/0/1)#