MROTEK PINE-16M, Configuration Manual

Page: 28 / 100

Configuration of the Ethernet interface of PINE-16M
4-12
4.5.2 Set up auto-negotiation
When the auto-negotiation function is enabled, duplex mode and the data rate cannot be configured
manually.
By default auto-negotiation function is enabled for all the Ethernet ports.
Command Description
config
Enter the global configuration mode.
interface eth
<1-2> To Select a specific Ethernet interface of PINE-16M.
autonegotiate
To enable auto-negotiation function for the selected Ethernet
interface.
show interface
Shows the configuration information of the interface
Using the command ‘
no autonegotiate
’ user can disable the auto-negotiation function.
Example
: enable the auto-negotiation function.
Mro-tek#
config
Mro-tek(config)#
interface eth
1
Mro-tek(config-eth/0/1)#
autonegotiate
setup successfully!
Mro-tek(config-eth/0/1)#
4.5.4 Set up rate and duplex mode for the interface
Command Description
config
Enter the global configuration mode
interface eth
<1-2> To Select a specific Ethernet interface of PINE-16M.
speed
(10|100)
duplex
(full-duplex|half-duplex)
To Select the rate and duplex mode of selected Ethernet interface.
show interface
Shows the configuration information of the interface.
The Rate and Duplex mode can be defined only when the auto-negotiation function is
disabled.
Example:
Mro-tek#
config
Mro-tek(config)#
interface eth
1
Mro-tek(config-eth/0/1)#
speed
100
duplex
full-duplex
setup successfully!
Mro-tek(config-eth/0/1)#