ioLogik W5300
Utility: ioAdmin
3-25
Active Tags
A tag selection table shown in the right panel of the browser window shows the details of your selection.
The I/O status of a channel can be updated to the Active OPC Server once it is changed, or updated periodically.
1.
Check the
On Change
checkbox to force an update
when there is a signal change
for that channel (On-to-Off
or Off-to-On for digital
channels, or any fractional
change for analog channels).
2.
To periodically update the
status of the Active OPC
Server, specify a time
interval after the
Update
per
checkbox.
NOTE:
1.
A
Virtual Channel
is updated
periodically; the time interval for
updates can be set to seconds,
minutes, hours, or days, with
values ranging from 1 to 65535.
2.
If AI is configured to update
on
change
, the percentage settings
represent the percentage of the full
analog range. For example, if the AI
is configured for 0 to 10 V,
on
change 1%
means the ioLogik will
update the Active OPC Server every time there is a change of 0.1 V.
3.
Expansion modules
added to the system are
displayed in the modules
list. Select a module to
see detailed tags in the
right panel of the browser
window. After selecting
the needed tags click the
Create Tags
button. The Active OPC server will receive these updated tags the
next time you use Active OPC server.
Refer to the
Active OPC Server
section for more details about how to use Active OPC server.
ATTENTION
1.
Active OPC Setting
should be configured before connecting to the cellular network. If the settings are
not configured, the ioLogik W5300 won’t connect. When the ioLogik W5300 is in sleep mode, the
heartbeat signal will be disabled.
2.
The
RSSI
and
Internal Registers
tags require firmware version 1.3 or above for the ioLogik W5312
series, and 1.5 or above for the ioLogik W5340 series.