WS5100 Series Switch CLI Reference Guide
12-4
12.1.4 duplex
Interface Config Commands
Specifies the duplex mode of operation
Syntax
duplex(auto|full|half)
Parameters
Usage Guidelines
The duplex defines the communication used by the port. The switch (by default) is set in
the auto duplexmode. In auto mode, the duplex is selected based on connected network
hardware
NOTE:
• Duplexity can only be set for an Ethernet Interface. Enter the
(config-if)
instance using the
eth
parameter of the
interface
mode
• The duplex can not be set until the speed is set to a non-auto value
auto
The port automatically detects whether it should run in full
or half-duplex mode
full
Sets the port in full-duplex mode
half
Sets the port in half-duplex mode
Summary of Contents for WS5100 Series
