Motorola EX-3524, Cli Reference Manual

Page: 283 / 617

Chapter 9
| Access Control Lists
MAC ACLs
– 283 –
Related Commands
ipv6 access-group (282)
MAC ACLs
The commands in this section configure ACLs based on hardware addresses, packet
format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports.
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode. Use
the
no form to remove the specified ACL.
Syntax
[ no ] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
When you create a new ACL or enter configuration mode for an existing ACL,
use the
permit or deny command to add new rules to the bottom of the list.
◆
To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
◆
An ACL can contain up to 128 rules.
Table 58: MAC ACL Commands
Command Function Mode
access-list mac Creates a MAC ACL and enters configuration mode GC
permit, deny, redirect-to Filters packets matching a specified source and destination
address, packet format, and Ethernet type MAC-ACL
mac access-group Binds a MAC ACL to a port IC
show mac access-group Shows port assignments for MAC ACLs PE
show mac access-list Displays the rules for configured MAC ACLs PE