Chapter 21
| LLDP Commands
– 507 –
Any number of CA type and value pairs can be specified for the civic address
location, as long as the total does not exceed 250 characters.
◆
For the location options defined for
device-type
, normally option
2
is used to
specify the location of the client device. In situations where the client device
location is not known,
0
and
1
can be used, providing the client device is
physically close to the DHCP server or network element.
Example
The following example enables advertising location identification details.
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-location civic-addr
Console(config-if)#lldp med-location civic-addr 1 California
Console(config-if)#lldp med-location civic-addr 2 Orange
Console(config-if)#lldp med-location civic-addr 3 Irvine
Console(config-if)#lldp med-location civic-addr 4 West Irvine
Console(config-if)#lldp med-location civic-addr 6 Exchange
Console(config-if)#lldp med-location civic-addr 18 Avenue
Console(config-if)#lldp med-location civic-addr 19 320
Console(config-if)#lldp med-location civic-addr 27 5
Console(config-if)#lldp med-location civic-addr 28 509B
Console(config-if)#lldp med-location civic-addr country US
Console(config-if)#lldp med-location civic-addr what 2
Console(config-if)#
lldp med-notification
This command enables the transmission of SNMP trap notifications about LLDP-
MED changes. Use the
no
form to disable LLDP-MED notifications.
Syntax
[
no
]
lldp med-notification
Default Setting
Enabled
6
Group of streets below the neighborhood level
Exchange
18
Street suffix or type
Avenue
19
House number
320
20
House number suffix
A
21
Landmark or vanity address
Tech Center
26
Unit (apartment, suite)
Apt 519
27
Floor
5
28
Room
509B
Table 109: LLDP MED Location CA Types (Continued)
CA Type
Description
CA Value Example
Summary of Contents for EX-3524
