Chapter 20
| Multicast Filtering Commands
IGMP Filtering and Throttling
– 481 –
permit, deny
This command sets the access mode for an IGMP filter profile. Use the
no
form to
delete a profile number.
Syntax
{
permit
|
deny
}
Default Setting
Deny
Command Mode
IGMP Profile Configuration
Command Usage
◆
Each profile has only one access mode; either permit or deny.
◆
When the access mode is set to permit, IGMP join reports are processed when a
multicast group falls within the controlled range. When the access mode is set
to deny, IGMP join reports are only processed when a multicast group is not in
the controlled range.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#
range
This command specifies multicast group addresses for a profile. Use the
no
form to
delete addresses from a profile.
Syntax
[
no
]
range
low
-
ip-address
[
high
-
ip-address
]
low-ip-address
- A valid IP address of a multicast group or start of a group
range.
high-ip-address
- A valid IP address for the end of a multicast group range.
Default Setting
None
Command Mode
IGMP Profile Configuration
Command Usage
Enter this command multiple times to specify more than one multicast address or
address range for a profile.
Summary of Contents for EX-3524
