Motorola EX-3524, Cli Reference Manual

Page: 329 / 617

Chapter 12
| Power over Ethernet Commands
– 329 –
Note (EX-3524) : If power priority is not set for any ports, and there is not sufficient
power to supply all of the ports during bootup, available power is provided to the
ports based on the PSE chips in following order:
PSE#1: 12, 11, 10, 9, 8, 7, 6, 5, 4, 3, 2, 1
PSE#2: 24, 23, 22, 21, 20, 19, 18, 17, 16, 15, 14, 13
N
OTE
(EX-3548) : If priority is not set for any ports, and there is not sufficient
power to supply all of the ports, power is denied sequentially to PSE chip sets 1-4:
PSE#1 | PSE#2
1,0,3,2,5,4,7,6,9,8,11,10 | 13,12,15,14,17,16 19,18,21,20,23,22,25
PSE#3 | PSE#4
24,27,26,29,28,31,30,33,32,35,34,37 | 36,39,38,41,40,43,42,45,44,47,46
Note: For more information on using the PoE provided by this switch refer to the
Installation Guide .
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline priority 2
Console(config-if)#
power inline
time-range
This command binds a time-range to a port during which PoE is supplied to the
attached device. Use the
no form to remove this binding.
Syntax
power inline time-range time-range-name
no power inline time-range
time-range-name - Name of the time range. (Range: 1-30 characters)
Default Setting
None
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline time-range rd
Console(config-if)#
Related Commands
time-range (128)