Chapter 10
| Interface Commands
Interface Configuration
– 294 –
Interface Configuration
interface
This command configures an interface type and enters interface configuration
mode. Use the
no
form with a trunk to remove an inactive interface.
Syntax
[
no
]
interface
interface-list
interface-list
– One or more ports. Use a hyphen to indicate a consecutive
list of ports or a comma between non-consecutive ports.
ethernet
unit
/
port
unit
- Unit identifier. (Range: 1)
port
- Port number. (Range: 1-28/52)
port-channel
channel-id
(Range: 1-12)
vlan
vlan-id
(Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Example
To specify several different ports, enter the following command:
Console(config)#interface ethernet 1/17-20,23
Console(config-if)#shutdown
Power Savings
power-save
Enables power savings mode on the specified port
IC
show power-save
Shows the configuration settings for power savings
PE
Table 61: Interface Commands (Continued)
Command
Function
Mode
Summary of Contents for EX-3524
