34 • SECTION 2 — DRIVING & SAFETY
DYNASTY 2006
When preparing a tow plug connection strip the wires 3/8”. Twist the wire strands and place under the clip and
secure the screw. Make sure there are no loose strands of wire that could short against the case or other terminals.
Do not accidentally mirror image the trailer connection.
CAUTION:
Positive terminal connection of the tow plug remains live at all times. When towing a trailer
equipped with a battery, unplug the electrical tow connection when parked. Failure to
unplug the tow connection may result in discharged chassis batteries.
Brake Control
The motorhome is pre-wired and equipped with a US Gear D-Celerator tow brake control. The brake control
has adjustable gain settings and manual brake activation. The brake control also has a safety warning beeper that
will sound should the tow harness become unplugged.
NOTE
Refer to the OEM US Gear D-Celerator manual for complete operating and safety
instructions.
Gain Control:
The gain control adjusts the amount of braking force applied.
Adjust gain settings 1-9 so the towed vehicle appropriately applies
suffi cient braking force. Gain set too high will cause towed vehicle
wheel skid. Once set, the braking force applied to the towed
vehicle will mirror the amount of braking force of the motorhome.
The result is smooth progressive proportional braking. The amount
of braking action to the towed vehicle is refl ected in the light bar
display on the controller.
Manual Brake Activation:
The brake control is equipped with a manual lever to activate
the towed vehicles brakes. Moving the lever will apply increasing
force to the tow vehicles brakes. This manual lever can be used at
slow speed (below 10 MPH) to ensure the system is working.
CAUTION
Due to the weight of the motorhome and power of the engine, skidding wheels on a towed
vehicle will not be perceived from the cockpit of the motorhome.
INFORMATION
The brake control is only part of the US Gear D-Celerator Unified Tow Brake System.
Components not supplied by the motorhome manufacturer must be installed on the towed
vehicle to complete system installation. These components can be obtained from National
Parts @ 1-877-466-6226.
020301
Summary of Contents for DYNASTY 2006
