Monaco DYNASTY 2006, User Manual

Page: 344 / 384

344 • SECTION 10 — CHASSIS INFORMATION DYNASTY 2006
INFORMATION:
Refer to the engine manufacturers Owner’s Manual for more detailed information.
NOTE:
The engine is filled with 15-40w multi-viscosity oil from the factory. Generally this will start
the engine in temperature down to 15º F. If the engine has normalized to a temperature
below 15º F it will be necessary to pre-heat the engine before starting.
CAUTION:
Upon cranking an engine in cold temperature, the starter may rapidly engage and
disengage. If this occurs STOP attempting to crank the engine to prevent starter damage.
Pre-heat the engine before making further attempts to start.
Block Heat:
The switch on the dash labeled Block Heat operates the
receptacle for the block heater cord. The block heater is rated
between 850 and 1500 watts, depending on engine size. For
effi ciency hook to shore power, or plug the block heater cord to
a separate power cord rated for 15 Amps and a GFCI protected
outlet rated at 20 Amps. The engine may require several hours
of pre-heating before starting. It is recommended to start
preheating the engine the night before departure.
To Use the Block Heater:
• Hook to shore power and plug the block heater cord into
the block heater receptacle (both are located in the engine
compartment).
• Turn on the Block Heat switch.
Aqua-Hot (Optional) Engine Preheat:
The diesel burner inside the Aqua-Hot heats an internal engine coolant loop. When
the Aqua-Hot Engine Preheat switch is turned on, an engine coolant pump inside the
Aqua-Hot circulates heated coolant through the engine. The time it takes for the Aqua-
Hot to preheat the engine depends on ambient temperature. Allow at least three hours
of preheating before attempting to start the engine.
To Use the Engine Preheat System:
• Press the Aqua-Hot switch at the kitchen to turn the system on.
• Turn the Aqua-Hot Engine Preheat switch at the dash to the
ON
position. This
activates the engine pump inside the Aqua-Hot.
Tips:
1. When operating below 32º F, the Aqua-Hot and/or block heater preheat can enhance engine starting by
easing cranking and helping to prevent engine misfi re and white smoke during starting.
2. Always follow the recommended oil, fuel, and coolant specifi cations as outlined in the OEM Engine
Manual. Proper oil viscosity and coolant concentration eases engine starting and helps to avoid engine
damage.
3. Allow the engine to idle until it suffi ciently warms for operation. Utilize the fast idle feature to quicken
the process. Wait to operate the motorhome for at least three minutes or until the coolant temperature
begins to rise.
090480
BLOCK
HEAT
060066
AQUAHOT
ENGINE
PREHEAT
060066