Monaco DYNASTY 2006, User Manual

Page: 146 / 384

146 • SECTION 4 — APPLIANCES DYNASTY 2006
•
Low Tank Level Cutoff:
Heating function has shutdown
due to low level of coolant in the Aqua-Hot. Check
coolant level.
•
Electric Heating Element Status:
Green indicator
means the Aqua-Hot is being heated by 120 Volts AC.
•
Low Voltage Reset:
The Low Battery Voltage Fault
LED will illuminate. Reset the Controller by cycling
the Diesel burner switch or inserting a paperclip into the
hole. Press the reset button.
•
Heating Status:
The Aqua-Hot is being heated by Diesel
or the 120 Volt AC electric element.
•
Heating Zones Status:
A thermostat is calling for heat
in a zone. Normal LED is green. Red LED means a short
has occurred in that zone.
•
Pump Status:
When a pump is operating, LED is green.
A red LED indicates a short in the pump.
•
Low Battery Voltage Fault:
Red LED indicates that
battery voltage is low. Hook to shore power or start
the generator. The Aqua-Hot will not function until
the Electronic Controller is reset by cycling the Diesel
Burner switch off then back to on, or by inserting a
paperclip or similar tool into the Low Voltage Reset
hole. Press the Reset button.
Bay Thermostat
A small heat exchanger is located in the basement to help prevent
freezing in the water system during cold weather. This thermostat
turns the heat exchanger motor and Zone 2 pump on or off. The bay
thermostat is located in the curbside water service bay. Adjust the
thermostat between 40 and 50° F.
NOTE:
Turn on the diesel burner or electric element when
heating the bay.
020145
040486b
040486c
Electronic Controller
Bay Thermostat